Options; Battery Charger (B Suffix); Accessories - KEPCO HSM 3.3-230 Operator's Manual

1.5

OPTIONS

HSM options are described below:
1.5.1 BATTERY CHARGER (B SUFFIX): The battery charger option incorporates an expanded
window for the output voltage fault detector compatible with normal battery operating voltages.
1.6

ACCESSORIES

Accessories for HSM Power Supplies are listed in Table 1-3.
PART
ACCESSORY
NUMBER
RA 58
RACK
ADAPTERS
RA 61
-23E
RACK
ADAPTER
OPTIONS
-24E
124-0600
SERIES
CLAMPING
DIODES
124-0601
142-0422*
142-0381*
CONNECTORS 118-0776
108-0294
108-0203
219-0240
FIXED
INSTALLATION
KIT
219-0249
SCREW 101-0159
* Item (quantity 1) supplied with unit.
1-6
TABLE 1-3. ACCESSORIES
Accommodates up to three Power Supplies in a 19-inch rack. Used for hard-wired applications
only.
Same as RA 58 except accommodates up to four Power Supplies in a 24-inch rack for hard-
wired applications.
Incorporates wider mounting ears to accommodate a 23-inch rack; available for all 19-inch rack
adapters above.
Incorporates wider mounting ears to accommodate a 24-inch rack; available for all 19-inch rack
adapters above.
Used with HSM 24V, 28V and 48V models when wired for series operation. User must provide
wiring and heat sink. One diode required for each power supply. See PAR.2.7.5.3. May also be
used as optional external blocking diode for redundant applications. See PAR. 2.7.5.4.
Used with HSM 3.3V, 5V, 12V and 15V models when wired for series operation. User must pro-
vide wiring and heat sink. One diode required for each power supply. See PAR. 2.7.5.3. May
also be used as optional external blocking diode for redundant applications. See PAR. 2.7.5.4.
I/O connector mating plug
Source power inlet connector mating plug (IEC 320-C19)
North American linecord set (NEMA 5-20P to IEC 320-C19)
I/O connector backshell
I/O connector jackposts (set of two)
Standard - Kit consists of North American linecord set, I/O connector mating plug, I/O connec-
tor backshell, I/O connector jackposts, and screws for fixed mounting.
Customer-wired - Same as Standard Kit (Part No. 219-240), except linecord is replaced with
user-wired AC power inlet mating plug.
Used for fixed mounting of HSM Power Supply (#6-20, 0.625 in. long).
USE
HSMSERIES OPR 052912