Section 2 - Installation; Unpacking And Inspection; Terminations And Controls; Hsm Series Output Controls And Configuration Switch Functions - KEPCO HSM 3.3-230 Operator's Manual

2.1

UNPACKING AND INSPECTION

This instrument has been thoroughly inspected and tested prior to packing and is ready for
operation. After careful unpacking, inspect for shipping damage before attempting to operate.
Perform the preliminary operational check as outlined in PAR. 2.5. If any indication of damage
is found, file an immediate claim with the responsible transport service.
2.2

TERMINATIONS AND CONTROLS

a) Output and Configuration Controls: Refer to Figure 2-1 and Table 2-1.
b) Rear Panel: Refer to Figure 2-2 and Table 2-2.
FIGURE 2-1.

HSM SERIES OUTPUT CONTROLS AND CONFIGURATION SWITCH FUNCTIONS

SW
POSITION
S1-1
S1-2
S1-3
S2-1
S2-2
S2-3
S2-4
S2-5
S3-1
S3-2
S3-3
HSMSERIES OPR 052912

SECTION 2 - INSTALLATION

TABLE 2-1. CONFIGURATION CONTROLS
FUNCTION
REMOTE LOCKOUT RESET
CURRENT WALK-IN
UNDERVOLTAGE LOCKOUT
RANGE SELECT (VOLTAGE LOOP)
RANGE SELECT (FAULT DETECTOR)
EXT. VOLT. PROG. (VOLTAGE LOOP)
EXT. RES. PROG. (VOLTAGE LOOP)
INT. PROG. (VOLTAGE LOOP)
RANGE SELECT (CURRENT LOOP)
EXT. VOLT. PROG. (CURRENT LOOP)
INT. PROG. (CURRENT LOOP)
REF. PAR.
3.12
3.10
3.9
3.4
3.4
3.3
3.3
3.3
3.6
3.5
3.5
2-1