Quick Start-Up (Quick Programmer Menu) - Bosch RC35 Installation And Service Instructions Manual

Commissioning
5

5.3 Quick start-up (quick programmer menu)

B Press
button to open the quick operation menu.
SHORTPROG\
LOW LOSS
HEADER
SYSTEM
NO. OF MIXERS
HEATING CIRCUIT
1
(and other heating
circuits)
Table 9 Quick programmer menu navigator
22
Menu item
Have you installed a
module for the
hydraulic low loss
header?
Is a sensor for the low
loss header
connected?
Is heating circuit 1
installed (unmixed
heating circuit)?
How many mixed
heating circuits are
installed?
Which operating unit
is assigned to heating
circuit 1?
How should heating
circuit 1 be
controlled?
Which heating system
does heating circuit 1
have?
Standard
Input range setting
Yes, No no
No, at the no
boiler, at the
low loss
header
module
Yes, No Yes
0 to 3 0
RC2x/ RC35
RC20/RF,
RC35, none
Outside Outside
temperature temperatur
compensate e
d, room compensat
temperature ed
compensate
d
Radiator, Radiator
convector,
floor
SERVICE MENU
B
quick operation
settings
diagnosis
servicing
Other information
In association with
MCM10 the setting is
automatically set to
"Yes"the screen is
1)2)
hidden.
If a low loss header
module is used, connect
the temperature sensor
to the low loss header
3)
module.
Set the address on the
rotary coding selector of
the mixer module (basic
1)
setting HK2).
Assigning programming
units to heating circuits
( page 35). General
heating circuit data (
page 31).
Set up any other heating
circuits as per heating
circuit 1.
Heating curve (
page 36)
Logamatic EMS – 6 720 801 387 (2011/05)