About The Pxi-Core; Introduction; Quick Start - Bosch PXI-CORE Edge controller User Manual

8 en | About the PXI-CORE
3

About the PXI-CORE

3.1

Introduction

The PXI-CORE Edge controller is the HW base unit for smart integration. It consists of a
compact DIN-rail mountable hardware unit, Linux operating system and firmware. Smart
integration stands for integration between Bosch Building Technology systems and devices.
Next to this HW base unit the dedicated Intelligent control SW App for the PXI-CORE Edge
controller is required which is sold separately. Information of the Intelligent control App will
reveal the features and supported systems and devices.
This smart integration solution connects to IP based systems and devices utilizing the
available IP interface. The Intelligent control App is running on the PXI-CORE Edge controller.
Installation, updates and configuration of this App can be done remotely from any location via
the web-GUI. The PXI-CORE Edge controller is equipped with a Trusted Platform Module
(TPM) 2.0, has a full secure boot support, secured HTTPS web interface connection and
supporting CA signed certificates for authentication. All to ensure a high level of cyber
security.
3.2

Quick start

This quick start section of the manual describes the required steps to make the PXI‑CORE, and
installed application(s), up and running fast. For detailed instructions, refer to Detailed
installation procedures and instructions, page 10 .
Quick start procedure:
1.
2.
3.
4.
2023-03 | V01 | F01U395004
A
B
H
D
E
F
G
Connect the PXI‑CORE to the:
– Ethernet network (D) ( XF51). Connect your configuration device (PC, laptop, tablet)
to the same network that the PXI-CORE is connected to.
– External 24 V power supply (F) (XD10).
Power on the PXI-CORE via the connected power supply.
Check the device LED bar (H):
– red: power-up.
– blinking blue: starting up.
– green: ready to use.
Open your web browser and enter the IPv6 address (see product label):
– Example IPv6 address: https://[fe80::2680:34ff:fe84:62e0]. Be sure to type the
correct address (e.g. double colon after https://[fe80).
– Accept the risk for the self-signed certificate.
User manual
PXI-CORE Edge controller
Bosch Security Systems B.V.