Service - Bosch RC35 Installation And Service Instructions Manual

8

Service

With the service menu (not possible with boilers with UBA1.x and DBA) you can set a service
interval, and display and reset current service messages.
The interval can expire after a certain number of hours run or when a specific date is reached.
The RC35 programming unit will then show a service message so that the customer can notify
you to arrange an appointment.
Service messages are identified by a Hxx code, e.g. H07.
SERVICE MENU\
SERVICE
Maintenance interval
Current messages
RESET servicing
Table 22 Navigator for SERVICE MENU\SERVICE
1) Depending on the boiler used, additional service intervals may be able to be set at the boiler
programming unit.
Logamatic EMS – 6 720 801 387 (2011/05)
Menu item
How should
servicing
messages be
triggered?
For "by date":
annual servicing,
starting on:
For "by operation
hours": Boiler
hours run until next
service message
Message/code
Do you wish to
reset the servicing
messages?
Input Standard
range setting
No No
messages, messages
by date, by
operation
hours
2000-01-01 2000-01-
01
1,000 h to 1,000 h
6,000 h
no, yes no
Service
Other information
When selecting "date" or
"operating hours" the
system changes
automatically to the
corresponding setting.
Setting date:
Hold the button
pressed down and
simultaneously turn the
rotary selector.
Number of hours of
operation with burner
switched on.
Display further messages:
turn rotary selector.
When selecting "yes" all
service messages are
reset.
Observe the information
on the display.
8
1)
51