Installing The Lower Triple Clamp (Exc-F Six Days) - KTM 250 EXC-F EU Owner's Manual

SERVICE WORK ON THE CHASSIS
Installing the lower triple clamp
10.14
3 0 0 3
2 0 0 2
1 0 0 1
(EXC-F SIX DAYS)
x
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
101331-10
–
Position the upper triple clamp with the steering.
–
Mount screw
–
Position the clutch line, wiring harness, and voltage regulator. Mount and tighten
screws .

Guideline
Remaining screws, chassis
101337-10
–
Position the fork legs.
Info
The topmost milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
101338-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
101339-10
–
Tighten screw
Guideline
Screw, top steering head
101340-10
p. 112)

and O-ring .
 
but do not tighten yet.

toward the front.

.

.

is correctly positioned.
M6 10 Nm (7.4 lbf ft)
M8 12 Nm (8.9 lbf ft)
M20x1.5 12 Nm (8.9 lbf ft)
48