The Second Projector (Projector B); Stacking The Projectors; Connecting Projectors; Installing The Second Projector (Projector B) - InFocus IN5122 Manual

Hide thumbs Also See for IN5122:

Table of Contents

Place Projector B on Projector A when stacking both projectors. Make sure

the heel on the bottom of Projector B is inserted into the corresponding pock-

et on the top of Projector A.

With Projector B placed on Pro-

jector A, push Projector B's

elevator feet to extend the eleva-

tor feet without lifting Projector B.

Make sure the elevator feet reach

the bottom of the stack pockets

on Projector A.

CAUTION ►Be careful when

stacking both projectors, the pro-

jector on top may slide off.

Rotate Projector B's elevator feet

counterclockwise twice and leave a ~1mm gap between the protrusion at the

bottom of Projector B and the top of Projector A as shown in the figure.

• You must keep Projector B slightly away from Projector A except

NOTES

for the heel portion to prevent both projectors from resonating due to the

sound output from the built-in speakers.

• If Projector B is tilted any farther, Projector B's image may not superimpose

onto Projector A's image.

• If Projector A's elevator feet are used, make sure the tilt angle for both

projector is no greater than 12 degrees from level.

To use Smart Stack, connect an RS232 cross cable between the CONTROL ports

of Projector A and Projector B.

Installation

Table of Contents

In5124