Installing The Second Projector (Set B); Deciding Installation Position; Connecting Projectors; Setting Up Set B - InFocus IN5132 User Manual

2.3 Installing the second projector (Set B)

Deciding the installation position
Decide the position of Set B and its projection angle.
→
Arrangement
WARNING ►For IN5142, IN5144, IN5144a and IN5145 only: You can install
the projector in any direction with specified mounting accessories. Consult with
your dealer for that type of installation.
• Set the tilt angle of Set B within 9 degrees of the level line.
NOTE

Connecting projectors

To use Intelligent Stack, connect an RS-232 null modem cable between the
CONTROL port of Set A and Set B.

Setting up Set B

1.
Turn on Set B.
• After turning on Set B, verify the image of Set B is not significantly
NOTE
tilted compared to the image of Set A. If the image is overly tilted, rotate the
elevator feet of Set B to adjust the angle so that the tilt is just about right.
2.
Reset the adjustment of KEYSTONE and PERFECT FIT on Set B.
(Operating Guide
• KEYSTONE cannot be selected when PERFECT FIT is in use. To
NOTE
reset both functions, reset PERFECT FIT first.
• Set up the INSTALLATION settings first because the image position may
change. (Operating Guide
(continued on next page)
and
Adjusting the projector's
→ EASY MENU
→
elevator)
or SETUP
SETUP menu)
8
(User's Manual (concise)
menu)
Installation