6.
How to Reload a New Probe Cover
(1) Place a probe cover onto
the storage case hole
with paper side upwards.
(3) Completely push the
probe into the probe
cover holder hole.
NOTE:
• In order to avoid cross-contamination, please reload a new probe
cover for each measurement.
• Please check if the probe cover is fitted on firmly before use
(please see the diagrams below); If the probe cover is broken,
discard the probe cover and reload a new one immediately.
(X) Incorrect
(2) Take the unit, vertically
penetrate the probe into
the center part of the
probe cover.
(4) Take out the probe with
cover attached tightly.
(O) Correct
6