Table of Contents
Advertisement
[Hotspot Search Results] After enabling Wi-Fi, the camera will automatically search for
wireless networks in the area. When the camera is searching for a wireless network you will see
the following information listed: the name of the wireless router, signal intensity, and the
encryption type. Click on "add hotspot" or double-click on an existing hotspot to open the "Wi-Fi
Hotspot Setting" dialog box as the Figure 25 below shows:
If this screen was entered by double-clicking an existing hotspot, the hotspot will be assigned
automatically.
If this screen was entered by clicking "Add hotspot", then type in the SSID, corresponding
encryption mode, and the network password.
Click [Establish Connection] to establish a connection with the wireless network. You will be
presented with a success or a failure message with the result of this connection.
If connected, "Connected" will appear after hotspot name; if not, please click "Refresh" to
refresh connection status or click this button to search device again.
After saving all parameters, click the [Exit] button, and the settings will take effect immediately.
Now disconnect the network cable, and you can access the IP network camera via Wi-Fi.
Note
Wi-Fi modes supported by the IP Camera:
802.11b/g protocol (small power Wi-Fi type) 802.11a/b/g/n protocol (large power Wi-Fi type)
Figure 25
89
Advertisement
Table of Contents
