Table of Contents
Advertisement
Double-Click on your IP Camera in the IPC Search program, and you will have the option to change
some of the network settings (as Figure 3).
In the Networking tab of the IPC Config menu, you will need to change the settings of the camera to
match your router settings
1. In the IP field, type in the same IP address that appeared as the IPv4 Address on your ipconfig
results, but label the last three digits to a larger value such as 101.
2. In the Gateway field, type in the same numbers that appeared as the Default Gateway in your
ipconfig results.
3. In the Sub Mask field, type in the same numbers that appeared as the Subnet Mask on your
ipconfig results.
After adjusting all of these settings, click [Save]. The IP Address, Gateway, and Sub Mask should
update immediately after you click [Save].
Figure 3
(as Figure4).
Figure 4
75
Advertisement
Table of Contents
