Table of Contents
Advertisement
5. Click [Next], enter the default password"111111", and click [Done] to add the devices ( as Figure 9).
Now disconnect the network cable and place the camera anywhere within the Wi-Fi signal range.
Figure 9
▲Method Two: Manual Add
1. Click [Discovery], this will take you to the "Discovery" section. Click [Refresh], and your phone will
automatically search all local devices, then click on the 10-digit Device ID (found from the label on the
back body of the IP Camera) to add this camera to Zsight (as Figure 10).
Figure 10
Advertisement
Table of Contents
