Table of Contents
Advertisement
4.6.4 Alarm Settings
▲ Motion Alarm
Figure 34
[Protection time setting] Set the time frame during which you would like motion detection to be
active.
[Motion detection switch] Enable the time frame specified. If it is unchecked, the time frame is
not active. If it is checked, the motion detection time frame will be followed.
[Motion detection setting] After enabling the motion detection switch, the interface will appear
darker. Left-clicking the box will activate motion detection for that area and right-clicking the box
will deactivate motion detection for the area.
[Alarm action mode] Set the appropriate action to take once motion is detected. An e-mail can
be sent to the e-mail specified in the e-mail section of 4.6.2. If no e-mail settings are configured,
then an e-mail will not be sent.
[Sensitivity] The sensitivity of motion detection includes four levels: Highest, High, Medium, and
Low.
[Output delay] Set the delay time of alarm linkage. The time range is limited between 0~30.
After setting all parameters, click the [Submit] button.
Advertisement
Table of Contents
