Table of Contents
Advertisement
select a hotspot from the auto search list or manually add one (as Figure 65)
Figure 65
[Hotspot] Refers to SSID, which is the login name of wireless network for authentication, it must be
consistent with the SSID of the wireless gateway (router/AP). (Such as: TP-LINK_4A2DDC).
[Authentication Mode] Which can be selected from the following five encryption methods:
Unencrypted, WEP Encrypted, WPA PSK Encrypted, WPA 2 PSK Encrypted, WPA PSK + WPA2 PSK
Encrypted? This setting must be consistent with the security type of wireless gateway (router /AP).
Note: Router's wireless authentication mode cannot be set WEP Encrypted.
[Password] Refers to the authentication password of wireless network, this setting must be
consistent with the security type of wireless gateway (router /AP).
Click [Establish Connection] to establish a connection with the wireless network. You will be
presented with a success or a failure message with the result of this connection.
If connected, "Connected" will appear after hotspot name; if not, please click [Refresh Hotspot] to
refresh connection status or click this button to search device again.
After setting all the parameters, click the [Submit] button.
Now unplug the cable to enable the IP camera wireless access through a wireless network.
65
Advertisement
Table of Contents
