Securing The Child; Adjustment To The Body Size; Removing The Booster Inlay - CYBEX PallaS User Manual

SECURInG tHE CHIlD

Place the child seat on the respective seat in the car.
- Please make sure that the backrest (a) of the child seat rests flat against the
backrest of the car seat so that the child seat is under no circumstances in a
sleeping position.
- Should the headrest of the vehicle seat interfere, please pull it out completely and
turn it around or take it off entirely. The backrest (a) optimally adjusts to almost any
inclination of the vehicle seat.
Warning! the backrest of the CybEx child seat should rest flat against the
upright part of the car seat. pushing the booster rearwards the seat should be
tightly pressed against the seat. for the best possible protection of your child,
the seat must be in a normal upright position!
note! On some car seat covers made of sensitive material (e.g. velours, leather etc.)
the use of child seats may lead to traces of wear and tear. To avoid this, you should
put a blanket or a towel underneath the child seat.

aDjUStmEnt to tHE boDy SIzE

for proper height adjustment of the CYBEX child seat an inlay (i) is included and
already mounted under the seat cover when purchased.
- It is recommended to use this height adjustment inlay (i) between the age of 9 and
18 months.
- for children over 19 months the inlay may be removed
- Afterwards the height adjustment should be regulated by moving the headrest (e)
into the correct position. Pull the slider (h) in order to release the headrest.
- The seat is correctly adjusted if you can fit 2 fingers between the bottom edge of
the head rest and the shoulder of the child. Pull the adjustment handle (h) in order
to unlock the shoulder and headrest.
note! Only a shoulder and head rest (e) optimally adjusted in height provides the
best protection and comfort for your child and also guarantees the optimal position of
the diagonal belt (f). You can adjust the height (e) in 11 positions. The shoulder rest is
attached to the head rest and does not have to be adjusted separately.

REmovInG tHE booStER Inlay

1. Open the forefront press buttons of the booster cover.
2. Lift the booster cover until the seat inlay can be easily removed from the front.
3. Remove the seat inlay according to the above age recommendation.
4. Put the seat cover back in its original position and fasten the press buttons.
11