Installing Accessories; Introduction; Antistatic Protection - Konica Minolta bizhub C31P User Manual

Introduction

Note
Use of accessories not manufactured or supported by
KONICA MINOLTA will void your warranty.
Dual In-Line
Memory Module
(DIMM)
Duplex Option
Lower Feeder Unit
(Tray 3/4)
Hard Disk Kit
CompactFlash card 512 MB, 1 GB, 4 GB
Note
Installing accessories always requires that the printer and accessories
are turned off and unplugged during installation.

Antistatic Protection

Note
It's very important to protect the printer controller board from
electrostatic damage while performing any task involving the controller
board.
Turn off all power switches first. If an antistatic wrist strap is provided in
your printer option kit, attach one end of it to your wrist and the other
end to the bare metal chassis on the back of your printer. Never attach
the wrist strap to any piece of equipment with an electrical current
present. Plastic, rubber, wood, painted metal surfaces, and telephones
are not acceptable grounding points.
If you don't have an antistatic wrist strap, discharge your body's static
electric charge by touching a grounded surface before you handle any
printer boards or components. Also avoid walking around after
grounding yourself.
232
This chapter provides information about the following accessories.
256 MB, 512 MB DIMM
(DDR-SDRAM, 266 MHz, 184 pins, No ECC, Unbuf-
fered, CL=2 or 2.5)
Auto duplexing
500-sheet tray included
40 GB Hard Disk
Introduction