Konica Minolta bizhub C31P User Manual page 237

This message...
TRANS. BELT
END OF LIFE
TRANS.ROLLER
END OF LIFE
UNABLE TO
COLLATE JOB
UNABLE TO
STAPLE JOB
WASTE TONER
NEAR FULL
HUBS NOT SUPPORTED
DEVICE NOT
SUPPORTED
AUTH TIMEOUT
PORT AUTH ACTIVE
Status, Error, and Service Messages
means...
The transfer belt unit
has reached the end
of its life.
The transfer roller has
reached the end of its
life.
The hard disk is full.
Print jobs over 10,000
pages cannot be col-
lated.
A job set for stapling
contains pages that
exceed the number of
pages that can be sta-
pled.
The waste toner bot-
tle is nearly full.
A USB hub is con-
nected.
An incompatible
device is connected.
Log off from
IEEE802.1X port
authentication auto-
matically.
IEEE802.1X port is
processing.
do this...
Replace the transfer belt
unit and reset the
counter in the MAINTE-
NANCE MENU/SUP-
PLIES/REPLACE/
TRANS. BELT menu.
Replace the transfer
roller and reset the
counter in the MAINTE-
NANCE MENU/SUP-
PLIES/REPLACE/
TRANS. ROLLER
menu.
Print one copy of the file
at a time.
Reduce the printed
pages to the number
that can be stapled.
(Refer to page 135.)
Prepare a new waste
toner bottle.
Do not connect a USB
hub.
Do not connect an
incompatible device.
Set authentication of
IEEE802.1 port again,
and then log on.
Please wait until authen-
tication processing is
completed.
223