Finishing; Job Separation Printing - Konica Minolta bizhub C31P User Manual

Finishing

When the optional staple finisher is installed, job separation, offset and staple
printing can be performed. For the installation procedure, refer to "Staple Fin-
isher" on page 250. Settings can be specified for job separation, offset and
staple printing by selecting
MENU .
Use the following paper with job separation, offset and staple printing.
Media Types
Media Size
Paper is fed to the main output tray with job separation, offset and sta-
ple printing.

Job Separation Printing

When paper is fed to the main output tray, the pages are fed out shifted as
shown below.
When paper is fed to the sub output tray, the pages are fed out
stacked on top of each other without begin shifted.
If staple printing is selected, the pages are stapled together before
being fed out.
134
JOB SEPARATION
Plain paper, Recycled paper and Letterhead
(changes according to the paper thickness)
Width: 182 to 216 mm
Length: 257 to 355.6 mm
FINISHING
or in
Finishing
PAPER