Cab-1 Remote Controller Numeric Keypad Commands - Lionel American Flyer 2-8-2 Mikado Steam Locomotive and Tender Owner's Manual

TrainMaster Command Control operations

CAB-1 Remote Controller numeric keypad commands

W hen you press the AUX1 button on your CAB-1 Remote Controller, you
turn the numeric keypad into ten command buttons. These commands
are specific to your locomotive, and an overlay is included to help you learn
these functions. After you press the AUX1 button, you will be able to press any
numbered button until you address a different product. The corresponding
RailSounds sound system effects are in bold italic type.
Stops and resets the locomotive. Resets the locomotive's direction to forward. Resets the
RailSounds 5.0 sound system to Automatic Chuff Mode. Air release sound.
Raises the volume of the chuffing and boiler sounds. Sound volume increases. The
whistle, bell, CrewTalk dialog, and TowerCom announcements will play at full volume. Use
the volume control knob located under the hatch on top of the tender to adjust the volume.
CrewTalk dialog is an engineer-initiated radio conversation with the dispatcher. Depending
on the movement of the locomotive, the meaning of this dialog will change. The
RailSounds 5.0 sound system will often use different words and phrases when composing
the conversation. See page 15-16 for additional information. CrewTalk dialog
commences.
Starts the RailSounds 5.0 sound system if the locomotive was previously shutdown. Triggers
the water pump sounds. Activates Manual Chuff Mode (see page 20) to set the chuff
intensity manually. Water injector sounds.
Lowers the volume of the background effects. Sound volume decreases. The whistle,
bell, CrewTalk dialog, TowerCom announcements, and other user-controlled effects will
play at full volume. Use the volume control knob located under the hatch on top of the
tender to adjust the maximum volume of all effects.
Activates the steam locomotive shutdown sequence. If the locomotive is in motion, an
"emergency stop" dialog will play. If the locomotive is at rest, the engineer will sign-off.
Dialog and shutdown sequence.
Activates Manual Chuff Mode (see page 20) to set the chuff intensity manually.
Steam release sound.
TowerCom announcements are a dispatcher-initiated radio conversation with the engineer.
Depending on the movement of the locomotive, the dialog will change. The RailSounds 5.0
sound system will often use different words and phrases when composing the conversation. See
pages 15-16 for additional information. TowerCom announcement.
Turns off the smoke unit. Let-off sound.
Turns on the smoke unit if the smoke unit switch is in the ON position. Be sure to add
smoke fluid before turning on the smoke unit to prevent damage to your locomotive.
Let-off sound.
AUX1, 8 and 9 function only if the locomotive's smoke unit switch is in the ON
Note!
position.
19
AUX1