Table of Contents
Advertisement
4.1.3.2
Go to "Data" page. You can monitor the current working voltage of each channel.
Check Box
White
Red
Blinking
4.1.3.3
Go to "Alarm" page. You can setup the High/Low alarm value (Voltage or Current)
for each channel.
Alarm Channel: Select the channel.
Alarm Mode: Enable or Disable
High Alarm Value, Low Alarm Value: Type the value here.
Update: Activate the new setting.
SNMP Trap Server Setting: You can configure up to 4 SNMP Trap Server here.
Type the IP address and press "Update" to activate the new setting.
Select the check box to monitor the info of the channel.
Unselect the check box when you don't want to monitor it.
Afte enabled the alarm feature of the channel, these is a
white circle behind the channel.
The circle become to Red when the alarm is activated.
The indicator in the bottom of the Data Area means the utility
is monitoring the status of the channels. If there is error
occurred, the color become to red or not light.
15
Advertisement
Table of Contents
