Table of Contents
Advertisement
2.5
Wiring Earth Ground
To ensure the system will not be damaged by noise or any electrical shock, we suggest
you to make exact connection with JetI/O products with Earth Ground.
On the bottom side of JetI/O 6500 Series, there is one power earth ground pin in the
Power Input terminal block.
Pin No
1(+24V)
2(FGND )
3(0V)
2.6
Wiring Fast Ethernet Ports
JetI/O 6500 series includes 1 RJ45 Fast Ethernet ports. The fast Ethernet ports support
10Base-T and 100Base-TX, full or half duplex modes. The fast Ethernet port will
auto-detect the signal from connected devices to negotiate the link speed and duplex
mode. Auto MDI/MDIX allows users to connect another switch, hub or workstation without
changing straight through or crossover cables.
Connect one side of an Ethernet cable into the Ethernet port and connect the other side to
the attached switch or host. The link LED will light up when the cable is correctly
connected. Refer to the LED Indicators section for descriptions of each LED indicator.
Always make sure that the cables length between the 2 ends is less than 100 meters (328
feet).
The wiring cable types are as below.
10Base-T: 2-pair UTP/STP Cat. 3, 4, 5 cable, EIA/TIA-568 100-ohm (100m)
100 Base-TX: 2-pair UTP/STP Cat. 5 cable, EIA/TIA-568 100-ohm (100m)
1000 Base-TX: 4-pair UTP/STP Cat. 5 cable, EIA/TIA-568 100-ohm (100m)
2.7
Din-Rail Mounting Installation
The DIN-Rail clip is already attached to the JetI/O 6500 Series when packaged. If the
DIN-Rail clip is not screwed on the JetI/O, follow the instructions and the figure below to
attach DIN-Rail clip to JetI/O.
a. Insert the upper end of DIN-Rail clip into the back of DIN-Rail track from its upper side.
b. Lightly push the bottom of DIN-Rail clip into the track.
Description
DC+24V Power Input
Power Earth Ground
Referenced Ground for Power Input
7
Advertisement
Table of Contents
