Korenix JetI/O 6510 User Manual page 13

address is 192.168.10.3. You can directly connect the JetI/O one after one to change its
IP address. Or connect the JetI/Os to the same switch or network, then the host PC can
modify the IP address via the switch or network.
If you purchase several JetI/Os and connect them to the same network before change
their IP address. They must have the same default IP address, and you may not control
them well due to the IP conflict. At this time, you should change their IP address first.
The JetI/O' Block I/O configuration utility or Device Finder Utility can help you to do this.
Note 1: Device Finder Utility allows you to discover the JetI/Os which have the same IP
address. Change the IP address of the JetI/O one after one. After you configured the
new IP address for the unit, please notice whether the ARP table of the device is flashed
or not. If not, you can choose "Start -> Run", type "cmd" to open the DOS prompt. Use
"arp –d" to clear the ARP cache.
Note 2: You can find the detail progress, please refer to the next chapters.
10