Mx-Fn17 (Finisher) - Sharp MX-2010U Installation Manual

[22] MX-FN17 (FINISHER)

MX-3610N
1. Unpacking
A. Packed items check
1
3
6 7
11 12
16 17
No. Name
1 Finisher
2 Attachment
3 Blinding bottom plate
4 Front rail guide
5 Path guide
6 Open/Close cover
7 Left rear cover
8 Punch F cover
9 Fulcrum upper cover
10 Take-up roller
11 Screw (M4 x 10 S tight)
12 Screw (M3 x 6 S tight, with flange)
13 Screw (M4 x 7 S tight)
14 Screw (M3 x 6 S tight)
15 Clip
16 Fulcrum shaft
17 Staple position label (For the scanner)
18 Staple position label (For the RSPF)
19 Safety cover
20 Protection sheet
2
4 5
8 9 10
13 14 15
18 19 20
Quantity
1
1
1
1
1
1
1
1
1
1
1
4
5
3
1
1
1
1
1
1
MX-3610N MX-FN17 (FINISHER) 22 – 1
Service Manual
2. Installation
Check to confirm that the firmware version is later than below.
If the version is older, upgrade the firmware.
Firmware version: 01.02.03.00
Before installation, be sure to turn both the operation and main
power switches off and disconnect the power plug from the power
outlet. Make double sure that the data lamp on the operation panel
does not light up or blink when performing installation.
A. Paper holding arm and paper exit full detection
actuator removal
1) Remove the paper holding arm.
The paper holding arm must be removed together with the
paper holding arm holder. Since the paper holding arm is easy
to remove alone, be careful not to leave the paper holding arm
holder unremoved.
2) Remove the paper exit full detection actuator.