Sharp MX-2010U Installation Manual page 104

2) Fix the paper holding A with fixing screw A.
2
3) Attach the saddle tray and paper holding B.
2
1
(3) Staple cartridge attachment
1) Insert the staple cartridge.
1
MX-3610N MX-RB10/FN10 (PAPER PASS UNIT/FINISHER) 24 – 5
(4) Height adjustment of the saddle finisher
1) Put the saddle finisher closer to the main unit, and check to
insure that the guide pin is smoothly inserted into the connec-
tion hole.
Guide pin
If the guide pin is not inserted smoothly, perform the following
adjustment.
a. When the guide pin is not fit with the connection hole in the
saddle finisher:
1) Loosen the fixing screw of the adjustment section on the rear
side. Adjust the height adjustment screw so that the guide pin
is fit with the connection hole in the saddle finisher.
By making space between the main body and ground, the
adjustment screw can be turned by the finger.
2
2) Remove the front under cover and foot cover.
2
Connection hole
1
1
3