Sharp MX-2010U Installation Manual page 75

3) Attach the rear upper cabinet.
2
Check to confirm that the wire is not in contact with the har-
ness fixing plate.
If the wire should be in contact with the harness fixing plate
and the upper rear cabinet should be installed under this con-
dition, the wire may be caught between the both parts to be
damaged, causing a short circuit.
harness fixing plate
wire
D. Finish stamp cartridge attachment
1) Open the left cover, and open the document tray.
2) Attach the finish stamp cartridge.
1
1
2
2
harness fixing plate
wire
MX-3610N AR-SU1 (STAMP UNIT) 17 – 3
E. Turn ON the power of the main unit
1) Connect the power plug of the machine to the power outlet,
and turn ON the main power switch and the operation panel
power switch.
F. Installation check
1) Use SIM22-10 to check to confirm that the finish stamp (AR-
SU1) is recognized.