Configuring The Event Tab; Connecting A Spot Out / Camera Out Monitor (Dh230/250) - Digimerge DH230 Series Instruction Manual

Setting up Sequencing
9. Exit to the main viewing window. Press and hold the DISPLAY button for 2 seconds on the
remote or front panel to begin sequence view. To exit sequence view, press DISPLAY on the
remote or front panel or press the camera number on the remote.

Configuring the EVENT tab

The EVENT tab allows you to set up cameras to trigger each other. For example, you can set up
Camera 1 (front door) to trigger Camera 5 (side door) to be the main channel when someone
approaches Camera 1 (front door).
Scenario: Camera 1 triggers camera 5 to be the main camera
1. Beside CH1, select camera 5 under MOTION.
This tells camera 1 that if camera
Camera 1
5 detects motion, then camera 1
becomes the main channel.
2. Click ENTER to save your settings.

Connecting a SPOT OUT / CAMERA OUT monitor (DH230/250)

The SPOT OUT and VIDEO OUT ports allow you to connect addition monitors as outputs.
Connect the octopus cable
(16-channel only) to the CAMERA
OUT port , then connect loop out
monitors.
32
Connect a monitor to the VIDEO OUT or SPOT OUT
port (DH230) / CAMERA OUT port(DH250)
DH230
DH250