Configuring Alarm Output - Digimerge DH230 Series Instruction Manual

CMS-DH Central Management Software
• Parameter: Select the desired alert sound you want the computer to play.
5. Click Apply and then OK to save your settings.
6. Under Alarm Output, right-click the light bulb icon, and click Control.
7. Click Alarm Output On or Alarm Output Off. This depends on your device type (N/O or N/C).
8. Click Apply and then OK to save your settings.
When an alarm is triggered, the system will play a sound on the computer.

Configuring Alarm Output

To configure the alarm output type:
1. Under Alarm Output, right-click the light bulb icon, and click Control.
2. Click Alarm output on to enable the alarm out device, or Alarm output off to disable the
alarm out device
98
Click here to configure the Command
and Parameter settings