Jump-Starting - BMW R 1200 GS Rider's Manual

8
124
Insert side trim piece into sock-
et 1
Installing driver's seat (
z

Jump-starting

The wires leading to the
power socket do not have
a load-capacity rating adequate
for jump-starting the engine. Ex-
cessively high current can lead
to a cable fire or damage to the
motorcycle electronics.
Do not use the onboard socket
to jump-start the engine of the
motorcycle.
Touching live parts of the
ignition system with the
engine running can cause electric
shock.
Do not touch parts of the igni-
tion system when the engine is
running.
A short-circuit can result
if the crocodile clips of
the jump leads are accidental-
ly brought into contact with the
motorcycle.
70)
Use only jump leads fitted with
fully insulated crocodile clips at
both ends.
Jump-starting with a donor-
battery voltage higher than
12 V can damage the motorcycle
electronics.
The battery of the donor vehicle
must have a voltage of 12 V.
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Make sure that the motorcycle is
steady on its stand.
Make sure ground is level and
firm and park motorcycle.
Removing driver's seat (
When jump-starting the engine,
do not disconnect the battery
from the onboard electrical sys-
tem.
Remove protective cap from
positive battery terminal.
Begin by connecting one end
of red jump lead to positive ter-
minal of discharged battery and
other end to positive terminal
of donor battery.
Then connect one end of black
jumper lead to negative termi-
nal of donor battery, and other
end to negative terminal of dis-
charged battery.
As an alternative to the
negative battery terminal,
the spring strut bolt can also be
used.
69)