BMW R 1200 GS Rider's Manual page 114

with OE BMW Motorrad Integral
8
ABS:
During the following work,
112
parts of the front brake, in
particular of the BMW Motorrad
Integral ABS, can be damaged.
Take care not to damage the
brake system, in particular the
ABS sensor with cable and the
ABS sensor ring.
The ABS sensor can be
damaged when rolling out
the front wheel.
z
Watch the ABS sensor when
rolling out the front wheel.
Roll front wheel into front
wheel guide.
Raise front wheel, install quick-
release axle 5 and tighten to
appropriate torque.
Quick-release axle in axle
mount
37 lb/ft (50 Nm)
Tighten axle clamping screw 4
with appropriate torque.
Clamping screw of quick-
release axle
14 lb/ft (19 Nm)
Remove front wheel stand.
Ease brake calipers onto brake
disks.
with OE BMW Motorrad Integral
ABS:
The cable of the ABS sen-
sor could chafe through if
it comes into contact with the
brake disk.
Make sure that ABS sensor cable
is routed correctly.
Route ABS sensor cable 7 as
shown in picture.
Make sure that ABS sensor
cable is clipped into holder 8.