Jump-Starting - BMW F800GT Rider's Manual

Installing center fairing
7
panel
94
Slide center fairing panel at
left and right under fairing side
z
panels at position 1 and then
insert in guides 2 on left and
right.
All manuals and user guides at all-guides.com
Paint damage caused by
screw connection.
In the case of painted compo-
nents, plastic washers are to
be installed under the screw
heads.
Install four screws 1 on left and
right.
Fairings
1 lb/ft (2 Nm)
Install the seat (

Jump-starting

The wires leading to the
power socket do not have
a load-capacity rating adequate
for jump-starting the engine. Ex-
cessively high current can lead
to a cable fire or damage to the
vehicle electronics.
Do not use the socket to
jump-start the engine of the
motorcycle.
A short-circuit can result
if the crocodile clips of
the jump leads are accidentally
brought into contact with the
motorcycle.
Use only jump leads fitted with
fully insulated crocodile clips at
both ends.
Jump-starting with a donor-
battery voltage higher than
12 V can damage the motorcycle
52).
electronics.
The battery of the donor vehicle
must have a voltage of 12 V.