Table of Contents
Advertisement
Remove screws 2.
Remove the tank cover 3.
Installing tank cover
Make sure that the six brack-
ets 2 engage in the retaining
lugs 3 and the four connect-
ors 5 engage in the mounting
clips 4.
Install the tank cover 1.
https://www.motorcycle-manual.com/
Fit screws 2.
Fit screws 1.
Installing seat (
124).
Jump-starting
ATTENTION
Excessive current flowing
when the motorcycle is
jump-started
Wiring smoulders/ignites or dam-
age to the on-board electronics
If the motorcycle has to be
jump-started connect the leads
to the battery terminals; never
attempt to jump-start the en-
gine by connecting leads to the
on-board socket.
ATTENTION
Contact between crocodile
clips of jump leads and
vehicle
Risk of short-circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
greater than 12 V
Damage to the on-board elec-
tronics
Make sure that the battery of
the donor vehicle has a voltage
rating of 12 V.
Removing seat (
124).
When jump-starting the engine,
do not disconnect the battery
10
223
z
Advertisement
Table of Contents
