Leisure Time 5007 User Manual page 41

( E1 ) Long Angle Brace * 1 Hole * 30° - 60° * 1-1/2 x 3-1/2 x 85
5/16 X 4"
HEX
HEAD
BOLT
5/16" LOCK WASHER
5/16"
FLAT
WASHER
STEP 3
Thread a 3/8" Spike Tee Nut as shown in the illustration
so that you can pound it into the countersunk hole on one
Long Angle Brace E1. Once the Spike Tee Nut is firmly
embedded in the wood at the bottom of the hole, un-
screw and remove the bolt. This is the easiest way to
install the Spike Tee Nuts in a countersunk hole. You
only need to do this on one of the Long Angle Braces.
E1
SAE 3/8"
FLAT
WASHER
Y1
5/16 X 2018
NYLOCK
LOCK NUT
STEP 4
Attach the E1 Long Angle Braces to the B1 Beam End Post using a
3/8"x6-1/2" Hex Head Bolt, 3/8" Lock Washer, and 3/8" Flat Washer,
threading the bolt through the wooden parts into the Spike Tee
B1
3/8"
INTERNAL
TOOTH
LOCK
WASHER
( B1 ) Beam End Post * 3 Holes * 3-1/4 x 3-1/4 x 47
3/8"
SPIKE TEE
NUT
Nut installed in Step 3.
Tighten securely, but don't over tighten.
METAL TRIANGLE
STEP 2
Attach the two Metal Triangles
Y1 to the Swing Beam as shown
using two 4" Hex Head Bolts,
Lock Washers, Washers and 5/16
Nylock Lock Nuts. Tighten
securely, but do not over tighten.
Use any convenient
long 3/8" bolt.
3/8 X 6-1/2" HEX HEAD BOLT
Y1
E1
© Copyright Playground Inc