Leisure Time 5007 User Manual page 32

SHORT METAL HAND GRIP
2 REQUIRED
C1
G1
STEP 48
Stand Entry Ladder up and line up Ladder Rails
with pre-drilled holes and H12 Floor Rail and
using 3/16" drill bit pilot hole Entry Ladder Rails.
Then fasten ladder assembly using 2-1/2" Lag
Screws, Internal Tooth Lock Washers and Flat
Washers through H12 Floor Rail into Entry Ladder
Rails.
At this point, attach Y31 metal grip to ladder rails.
Measure down 4" from top edge and drill a pilot
hole in center of the board with 3/16" drill bit.
Attach handles at these points using 2 ½" lag
screw, lock washer and flat washer. Now use hole
in bottom of handle as guide to pilot drill and finish
attaching with 2 ½" lag screw, lock washer and
flat washer.
Next Generation 5007 061206
Y30
H12
Y31
E1
M11
Y3
4"
C3
Y31
Y30
E1
5 1/4"
STEP 49
Measure up 5-1/4" from H12 Floor Rails and
mark center of C1 and C3 Posts. Pilot drill using
3/16" drill bit. Now Attach Y30 Metal Hand Grips
to each Post with 5/16 x 2-1/2" Lag Screws,
Internal Tooth Lock Washers and Flat Washers.
Using hole in Y30 Hand Grip in top as guide, pilot
drill and finish attaching with 2-1/2" Lag Screws,
Internal Tooth Lock Washers and Flat Washers.
Page 31
1
5/16 X 2-1/2"
SCREW
C1
5/16" FLAT
WASHER
5/16"
INTERNAL
TOOTH
LOCK
WASHER
LAG
C3
Y30
© Copyright Playground Inc