Leisure Time 5007 User Manual page 28

M6 Club House Wall Board * 4 Holes * 28 Req
11/16 x 3-3/8 x 29 [ 1.74 x 8.57 x 73.66 ]
H9 Wall Rail * 2 Holes * 2 Req
1 x 3-1/2 x 45 [ 2.54 x 8.89 x 114.30 ]
N2
M6
M6
C3
M9 M9
STEP 40
Install 5/16" Spike T-Nuts inside C3 Posts and attach H9 using 5/16 x 3-3/4" Hex Bolts, Internal Tooth Lock
Washers and Flat Washers. Measure up 3-1/2" from top of H7 Floor Rail and mark C3 Post. Now attach H9
with bottom of H9 Wall Rail at marks on Post, pilot drill using 3/16" bit and attach using 2-1/2" Lag Screws,
Internal Tooth Lock Washers and Flat Washers. Make sure that H9 is flush with outside of C3. Now attach six
M9 Wall Boards to H9 Wall Rails on right side of Tower spacing approximately 2-3/4" apart using 1-1/2" Wood
Screws.
Next Generation 5007 061206
M9 Wall Board * 4 Holes * 23 Req
11/16 x 3-3/8 x 23 [ 1.74 x 8.57 x 58.42 ]
G2
H9
M9
M9
M9
H9
H7
STEP 39
Attach six M6 Wall Boards and one N2 on back
left placing three M6s, then one N2 and the
remaining three M6s then Space evenly and
Fasten using 1-1/4" Wood Screws in Bottom
Rail and 1-1/2" Wood Screws in Top Rail. Now
repeat on front left and front right of Tower
Assembly.
M9
C3
Page 27
N2 Club House Wall Board * 2 Holes * 3 Req
11/16 x 2-1/2 x 29 [ 1.74 x 6.35 x 73.66 ]
5/16" FLAT
WASHER
5/16"
SPIKE TEE
NUT
5/16"
INTERNAL
TOOTH
LOCK
WASHER
5/16 X 3-3/4"
HEX
HEAD
BOLT
#8 X 1-1/2
WOOD
SCREW
5/16 X 2-1/2"
LAG
SCREW
© Copyright Playground Inc
#8 X 1-1/4 "
"
WOOD
SCREW