Rack-Mounting The Switch - HP 1910 Getting Started Manual

Rack-mounting the switch

This task requires two persons. To mount the switch in a rack:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded.
Check that the rack is well grounded and can support the weight of the switch chassis and all its
2.
accessories.
Check that the mounting brackets have been securely attached to the switch chassis.
3.
Install cage nuts (user-supplied) in the mounting holes in the rack posts.
4.
One person holds the switch chassis and aligns the oval holes in the brackets with the mounting
5.
holes in the rack posts, and the other person attaches the mounting brackets with M6 screws
(user-supplied) to the rack, as shown in
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf, slide the switch to an appropriate
location, and attach the switch to the rack with the mounting brackets.
Figure 29 Mounting the V1910-16G chassis in a rack
Figure 29, Figure 30,
14
Figure 31, or Figure 32.