HP 1910 Getting Started Manual page 36

*
*
*
************************************************************************
Copyright (c) 2010-2011 Hewlett-Packard Development Company, L.P.
Creation Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
Memory Size
Flash Size
CPLD Version
PCB Version
Mac Address
Press Ctrl-B to enter Extended Boot menu...5
In normal startup mode, the waiting time here is five seconds. If you press Ctrl + B within five seconds, the
Boot ROM menu is displayed. If you perform no operation or press a key other than Ctrl + B within five
seconds, the system begins to automatically start up and the following information is displayed:
Starting to get the main application file--flash:/V1910-CMW520-A1101.bin!......
................................................................
The main application file is self-decompressing................................
...............................................................................
..............................Done!
System is starting...
Board checking..........................LS51LTSR
SDRAM fast selftest..........................OK!
Flash fast selftest..........................OK!
CPLD selftest................................OK!
Switch chip selftest.........................OK!
PHY selftest.................................OK!
Please check leds......................FINISHED!
User interface aux0 is available.
Press ENTER to get started.
Press Enter at the prompt, and you can configure the switch when the prompt <HP> appears.
NOTE:
For more information about the configuration commands and CLI, see the configuration guides and
command references for your switch.
HP V1910-24G Switch JE006A BOOTROM, Version 135
: Jan 9 2011
: ARM926
: 32KB
: 333MHz
: DDR2 SDRAM
: 128MB
: 128MB
: 001
: Ver.B
: 000ef2001910
32
*
*
*