Powering On The Switch; Verification Before Power-On - HP 1910 Getting Started Manual

Powering on the switch

Verification before power-on

Before powering on the switch, verify that:
The power cord is properly connected.
•
• The input power voltage meets the requirement of the switch.
The console cable is properly connected, the terminal or PC used for configuration has started, and
•
the configuration parameters have been correctly set.
Powering on the switch
Power on the switch, for example, an HP V1910-24G switch, and you can see the following information:
Starting......
************************************************************************
*
*
*
************************************************************************
Copyright (c) 2010-2011 Hewlett-Packard Development Company, L.P.
Creation Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
Memory Size
Flash Size
CPLD Version
PCB Version
Mac Address
Press Ctrl-B to enter Extended Boot menu...1
Press Ctrl + B at the prompt within one second to access the Boot menu, or wait for the system to
automatically start up.
NOTE:
The system has two startup modes: full startup and fast startup. By default, the system starts up in fast mode
and the waiting time is one second. In full startup mode, the waiting time is five seconds. To change the
startup mode, see
• If you press Ctrl + B within one second, the system displays a prompt for password:
Password:
Press Enter at the prompt the first time you access the switch and you can see the following Boot
menu:
HP V1910-24G Switch JE006A BOOTROM, Version 135
: Jan 9 2011
: ARM926
: 32KB
: 333MHz
: DDR2 SDRAM
: 128MB
: 128MB
: 001
: Ver.B
: 000ef2001910
"Changing the startup mode."
29
*
*
*