Testing The Siren; Deleting A Siren - Electronics Line iconnect Installation Manual

4. Mount the Siren to the mounting bracket by turning the Siren clockwise.
5. Secure the captive locking screw (see Figure 3-1)

5. Testing the Siren

Once the Siren has been registered test the unit according to the following testing
procedure:
To perform a Siren test
1. Go to the main menu and select [7]>[0]>[3]>[1] (Service> Tests> WL Siren Test).
2. Select a siren from the list (1-4) and press '√ʹ. The selected Siren is sounded
briefly.

6. Deleting a Siren

To delete a Siren from the system:
1. Set the system to Delete mode.
2. Go to the main menu and select [9]>[1]>[5]>[1] (Programming > Devices >
Siren>WL Siren)
3. Select a siren from the list (1-4) and press '√ʹ.
4. Press >3, and press'√ʹ. Upon the 'OK' confirmation request, press ʹ√ʹ
5. Open the Siren and take out the battery.
6. Press the tamper switch. While the tamper switch is being pressed insert the
battery. Within five seconds open the tamper and close it again.
Mounting
Bracket
Figure 4-1: Attaching the mounting bracket
Tamper
Protection
Screw
5