Testing The Siren Strobe; Deleting A Siren Strobe - Electronics Line iconnect Installation Manual

2-way wireless outdoor siren strobe

Hide thumbs Also See for iconnect:

5. Testing the Siren Strobe

Once the Siren Strobe has been registered test the unit according to the following testing

procedure:

To perform a Siren Strobe test

Go to the main menu and select [7]>[0]>[3]>[1] (Service> Tests> WL Siren Test).

Select a siren from the list (1-4) and press '√ʹ. The selected Siren is sounded

briefly.

To delete a Siren Strobe from the system:

Set the system to Delete mode.

•

Go to the main menu and select [9]>[1]>[5]>[1] (Programming > Devices >

Siren>WL Siren).

•

Select a siren from the list (1-4) and press '√ʹ.

•

Press >3, and press '√ʹ. Upon the 'OK' conﬁrmation request, press ʹ√ʹ

Open the Siren Strobe and take out the batteries

(see Figure 4-1).

Press the tamper switch. While the tamper switch is being pressed insert the

batteries. Within five seconds open the tamper and close it again.

Table of Contents