Sun Storedge T3 Array System Defaults; Boot Defaults; Table B-1 Default Settings-Set List - Sun Microsystems StorEdge T3 Service Manual

B
A P P E N D I X
Sun StorEdge T3 Array System
Defaults
This appendix lists the Sun StorEdge T3 and T3+ array defaults and is divided into
the following sections:
Section B.1, "Boot Defaults" on page B-1
Section B.2, "System Defaults" on page B-2
Section B.3, "Volume Defaults" on page B-3
Section B.4, "Default Directories and Files" on page B-4
B.1

Boot Defaults

Specify boot defaults with the set command. When run without any parameters,
the set command displays the current values. See the Sun StorEdge T3 and T3+
Array Administrator's Guide for information on using the set command.
TABLE B-1
Parameter
bootmode
bootdelay
sn
ip
netmask
gateway
tftphost
Default Settings—set List
Default
Variables
[auto | tftp | none]
auto
Number of seconds
3
Number Serial number
n.n.n.n Unit IP address
Unit netmask
255.255.255.0
n.n.n.n Network gateway IP address
n.n.n.n IP address of TFTP server
B-1