FLUE VENTING
10.
The D-30 Insert must be vented vertically to the outside and must use the Mendota flexible ducting system.
There are two methods for venting Mendota Direct Vent Inserts: 1) Co-Axial and 2) Co-Linear
CO-AXIAL VENT KIT (Typically for factory built ZC fireplaces.)
NOTE: THE INSERT IS DESIGNED, TESTED AND LISTED FOR OPERATION ONLY WITH MENDOTA
INSERT VENTING COMPONENTS AS LISTED IN FIGURES 3 & 4 AND DRAWING BELOW.
CO-LINEAR VENT KIT (Typically for masonry fireplaces.)
FIGURE 3
NOTE: Either vent kit may be used in any chimney if damper area size permits.
7