Mendota SEABROOK D-30 Installation & Operating Instructions Manual page 13

21. FINAL VENT BOOT ADAPTER INSTALLATION
A. Place u-clamp over threaded rod. Thread clamping nut on threaded rod and tighten firmly.
B. Reinstall exhaust baffle by placing rear edge on ledge, swinging front edge upward and
reinstalling two (2) sheet metal screws. CAUTION: The exhaust baffle must be reinstalled
before operation.
CO-LINEAR VENT
ADAPTER BOOT
FRONT
FIBERGLASS
SEAL DOUGHNUT
U-CLAMP
5/16" NUT
SIDE VIEW
85-03-00509
CO-LINEAR
CO-AXIAL
12
THREADED ROD