Majestic Vermont Castings Chateau DVT38S2 Installation Instructions And Homeowner's Manual page 23

FP1466
Fig. 40 Place volcanic rock on lower refractory in front of
burner housing.
FP1470
Fig. 41 Place ember material on burner tubes on both sides
of burner.
Refer to Figures 42 & 43 for final log positions.
5. Hold the "log front left" (F3) with the narrower end
toward the right. Set the log on the inside left side of
the fettle and bring it forward until the right end of
the log comes through the opening in the fettle.
(Fig. 42) When in place, the left end of the log is
supported above the left sheet metal bracket.
6. Hold the "log right front" (F2) with the pointed end
toward the left. Set the log on the inside right side of
the fettle and bring forward. The pointed end of the
log should come in contact with the front left log.
When in place, the right end of the log is supported
above the sheet metal bracket toward the right.
7. Repeat Steps 5 & 6 for the opposite side of the
burner. NOTE: Left and right logs will still be
treated left/right as you face the unit.
20007172
Volcanic Rock
Fig. 42 Place logs front left and right front.
NOTE: It is very critical to complete the next steps with
NOTE: Pin locators on logs placed in Steps 5 through
Ember Material
8. The "log top middle" (F5) is to be located toward the
9. Positioning "log top center" (F10) is very critical.
10. The "log top left" (F6) is to be located toward the
Chateau Decorative Gas Appliance
™
Log Front Left
(F3)
the valve box assembly on the left as you face the
unit. The performance of the unit may be affected if
the "log top center" (F10) is not located properly.
Also note the pins located on the logs already in the
unit will not be utilized.
7 (F2, F3) will not be utilized when placing logs F5,
F6 and F10.
right. Position this log to hide the pins protruding
from the existing logs.
Follow these measurements to properly position this
log. Identify "log top center" (F10). It is the log with
the hole in the middle. Hold the log with the nar-
rower end closest to you. Set the log on top of the
existing logs in the middle. Refer to Figure 44 for
proper distances from this log to the side refractory.
left. Position this log to hide the pins protruding from
the existing logs.
Log Right
Front (F2)
Fettle Opening
LG327
23