Terminals And Connectors - Eiki EIP-UHS100 Owner's Manual

Terminals and Connectors

IN OUT
HDMI
DVI-D B/Pb G/Y R/Pr WIRED REMOTE TRIGGER
LAN RGB
V H RS-232
SDI
Input SDI signals to IN and outputs the SDI signals from OUT.
HDMI
Connect the HDMI signal from the video device to this terminal.
DVI-D
Connect the DVI-D output on the computer to the terminal, the terminal can support to
HDCP compatible signal.
5 BNC INPUT JACKS
Connect the RGB signals or YPbPr singals.
WIRED REMOTE
Connect the wired remote control to this jack with a remote control cable (supplied).
TRIGGER
The TRIGGER terminal provides 12V (+/-1.5) output for screen control.
LAN
Connect the Ethernet cable to the terminals for controlling the projector. (page 62)
RGB
Connect a computer output (Analog D-sub 15-pin type) to this terminal.
RS-232
Connect a RS-232(Not supplied) from the computer to the terminal for controlling the
projector.
13