Osd Introduction - Lamps - Eiki EIP-UHS100 Owner's Manual

OSD Introduction – LAMPS
Mode
Use ◄ or ►function to select single or dual lamp mode.
Power
Use ◄ or ►function to select Eco, Normal, or Custom Power Level.
High Altitude
Use this function to switch the projector's cooling fan for high-altitude circumstances. You
can set it to Off or On. The default setting is Off.
Under normal circumstances, the projector will operate normally with this function set
to Off. If you were to operate the projector in environment of excessive heat or in areas
of high altitude, the projector may automatically shut down due to overheat. When this
happens, you can enable this function by setting it to On to force the cooling fan to work at
a higher speed to regulate the temperature inside the projector.
Note:
High altitude region refers to area with elevation over 5000 feet
Custom Power Level
Use this function to fine-tune the brightness. You can set power range from 80.4% to
100%.
Lamp 1 Status
Displays the Lamp 1 status.
Lamp 2 Status
Displays the Lamp 2 status.
43