Osd Introduction - Service - Eiki EIP-UHS100 Owner's Manual

Trigger
The projector comes with one set of Trigger output. You can configure one devices
connected to the projector via the trigger port to be automatically turned on when the
projector is on. There will be a 2-3 second delay prior to activation to prevent operation of
this function when the user is choosing an aspect ratio.
5:4: Outputs 12V of power on Trigger when Aspect Ratio is set to 5:4.
4:3: Outputs 12V of power on Trigger when Aspect Ratio is set to 4:3.
16:10: Outputs 12V of power on Trigger when Aspect Ratio is set to 16:10.
16:9: Outputs 12V of power on Trigger when Aspect Ratio is set to 16:9.
1.88: Outputs 12V of power on Trigger when Aspect Ratio is set to 1.88.
2.35: Outputs 12V of power on Trigger when Aspect Ratio is set to 2.35.
Letterbox: Outputs 12V of power on Trigger when Aspect Ratio is set to Letterbox.
Native: Outputs 12V of power on Trigger when Aspect Ratio is set to Native.
Unscaled: Outputs 12V of power on Trigger when Aspect Ratio is set to Unscaled.
Auto: Outputs 12V of power on Trigger automatically.
Auto Search
Use ◄►to turn On/Off auto search.
Dynamic Black
Use◄► to turn On/Off dynamic black.
Language
See page 32.
OSD Introduction – SERVICE
The functions covered in this unit relate to the display of some basic information about the
projector.
Note:
Memory of the custom timing files will be erased in the Factory Reset operation.
49