Basic Operation; Turning On The Projector; Turn Off The Projector - Eiki EIP-UHS100 Owner's Manual

Basic Operation

Turning On the Projector

① Complete peripheral connections (with a computer, VCR, etc.) before turning on the
projector. ② Connect the projector's AC power cord into an AC outlet and turn on the MAIN
ON/OFF Switch. ③ Press the "POWER" button on the side controller or On button on the
remote control. The LAMP indicator flashes green and the cooling fans start to operate, it
will take a few seconds to display the projected image on the screen.

Turn Off the Projector

1. Press the POWER button on the side control or OFF button the remote control, and
"Enter Standby mode?" message appears on the screen.
Enter STANDBY mode?
Yes : Press Again
No : Please Wait
2. Press the POWER button or OFF button again to confirm, or wait a few seconds to
cancel.
3. If the LAMP indicator lights bright and the POWER indicator turns off. After the projector
is turned off, the cooling fans operate. You cannot turn on the projector during this
cooling down period.
4. When the projector has cooled down enough, the POWER indicator lights green and
then you can turn off the MAIN ON/OFF Switch, wait until the projector is completely
cooled. Unplug the AC power cord from the AC outlet.
POWER
MENU
POWER INPUT AUTO SYNC ASPECT
POWER
STATUS
LAMP 1
ENTER
LAMP 2
MENU EXIT
SHUTTER
INPUT AUTO SYNC ASPECT
ENTER
EXIT
TEMP.
29
POWER
STATUS
LAMP 1
LAMP 2
TEMP.
SHUTTER