Installing The Projector In Proper Directions; Positioning Precautions - Eiki EIP-UHS100 Owner's Manual

Prevent the power cord from being treaded or pressed, especially the power cord near
the plug, outlet and the connection between the power cord and the equipment.
Unplug the power cord during a lighting or when the equipment is not used for long
periods.
Do not stare directly at the lens when the projector is running.
Do not attempt to service this projector yourself as opening or removing covers may
expose you to dangerous voltage or other hazards. Refer all servicing to qualified service
personnel.
When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer that have the same characteristics as the
original part. Unauthorized substitutions may result in fire, electric shock, injury to persons
or projector damaged.
The +12V trigger only outputs 12V DC trigger signal. Do not connect to other power
input or output. Otherwise, the equipment may be damaged.
Blocking the air vents by dust and leaving the projector uncleaned for a long time may
cause a breakdown, damage the projector or accidents. Please clean or change the filters
regularly. The packaging materials should be kept properly for the use of transportation.

Installing the Projector in Proper Directions

Use the projector properly in specified positions. Improper positioning may shorten the
lamp life and result in severe accident or fire hazard.
This projector can project the picture in upward, downward, or inclined position in
perpendicular direction to the horizontal plane.

Positioning Precautions

Avoid positioning the projector as described below.
15°
15°
CAUTION ON CEILING MOUNTING
For Ceiling mounting, you need the ceiling mount kit designed for the projector.
When the projector is not mounted properly, it may fail, causing hazards or injury.
For details, please consult you dealer. The warranty dose not cover any damage
caused by use of any non-recommended ceiling mount kit or installation of the
ceiling mount kit in an improper location.
Do not tilt the projector
more than 15 degree
from side to side.
In upward projection, do
not tilt the projector over
10 degree right and left.
10° 10°
7
Do not put the projector
on either side to project
an image.
In downward projection,
do not tilt the projector
over 10 degree right and
left.