Table of Contents
Advertisement
WE-2100T Series User's Manual
System Management> System Settings> Serial Command
Mode
The Serial Command Mode page is located under System Settings in the System Management
folder. This is where you specify how Serial Command Mode will be enabled. For details on Serial
Command Mode, please refer to Chapter 13.
Serial Command Mode
Default
Options
Description
S/W Trigger Character
Default
Options
Description
Disable
Disable, H/W control pin (DIO0), Activate by characters
This field specifies how to enter Serial Command Mode on the module.
Disable: Serial Command Mode will be disabled on the module.
H/W control pin (DIO0): Serial Command Mode will be activated according to
the signal received on DIO channel 0. This is used to set up a hardware trigger
through a switch connected to DIO 0. When the signal from DIO0 is low for at
least 200 ms, the WE-2100T will enter Serial Command Mode. Make sure that
DIO 0 is set to "DI" mode and an input device is properly connected.
Activate by characters: Serial Command Mode will be entered when three
trigger characters are received in rapid sequence (within 20 ms of each other).
The trigger characters are specified by S/W trigger character.
2b 2b 2b
00 to ff (hex)
This field specifies the three characters that will activate Serial Command Mode
if received in rapid sequence (within 20 ms of each other). Serial Command
Mode must be set to "Activate by characters".
Web Console: System Management
9-15
Advertisement
Table of Contents
