Table of Contents
Advertisement
WE-2100T Series User's Manual
1.
Select a valid IP address for your WE-2100T module. Consult with your network
administrator if necessary.
2.
Obtain the module's MAC address from the label on the module.
3.
From the DOS prompt, execute the arp -s command with the desired IP address and the
module's MAC address, as in the following example:
In this example 192.168.200.100 is the new IP address that you wish to assign to the module,
and 00-90-E8-xx-xx-xx is the module's MAC address.
4.
From the DOS prompt, execute a special Telnet command using port 6000, as in the
following example:
In this example, 192.168.200.100 is the new IP address that is being assigned to the module.
5.
You should see a message indicating that the connection failed.
6.
The module will automatically reboot with the new IP address. You can verify that the
configuration was successful by connecting to the new IP address with Telnet, ping, or
another method.
Assigning IP Address with Telnet Console
Depending on how your computer and network are configured, you may find it convenient to use
network access to set up your WE-2100T module's IP address. This can be done using the Telnet
program.
1.
Select Run... from the Windows Start menu.
2.
Enter the telnet command using your module's current IP address and click OK.
arp -s 192.168.200.100 00-90-E8-xx-xx-xx
telnet 192.168.200.100 6000
Initial IP Address Configuration
5-3
Advertisement
Table of Contents
